Blog

Fasteners for 3D Printing – Using Heat-Set Threaded Inserts | MatterHackers

Development News

I think we have found the solution to our tone ring assembly problem!  Snap fit connections were good for single use.  Screws on the other hand are great for reuse but hard to use with plastic parts. Enter…

PY18 Sprint 4 Stand Up 1

Stand Ups

TL;DR Off to a pretty good start.  Key social medial tools updated and most prep work for SyndCon is under way.  Hope to get the burn down closer to goal by the end of week 2. Backlog –…

PY18 Sprint 4 Stand Up 0

Stand Ups

TL;DR Initial commits for week 1 of Sprint 4.  Goals are to get our social media presence reestablished and get final orders of parts made. Backlog – See Syndcon Task List tab for current sprint plan and Backlog tab…

There and Back Again: An OSHW Project’s Tale – Part 2

Development News

This is the second in a series of posts recapping our 2017 Holoseat development and sharing our 2018 plan. In the first post we covered our 2017 goals and the reasons behind them. Today’s post is about how…

Alpha Status Update

Development News

Here we are going into November after hoping to be shipping our Alpha product by December…  So will we make it?  If you have been following the development posts on http://dev.holoseat.com (click the News link at the top)…

Good News Everyone! – HOLOSEAT AT SYNDCON 2017

Events

Like the picture says, good news!  Holoseat was back at SyndCon this year and we could not be happier with how the con went for us.  This year’s objectives were all about expanding our presence, introducing Holoseat v0.4,…

There and Back Again: An OSHW Project’s Tale – Part 1

Development News

This is the first in a series of posts recapping our 2017 Holoseat development and sharing our 2018 plan. In this post we look at the plan for 2017, aimed at taking a near production version of Holoseat…

2017 Sprint 3 Kickoff – Prep for SyndCon 2017

Development News, Events

The Big Picture The year is flying by. Sprint 2 is done and suddenly it is time to get everything ready for SyndCon 2017. Our last sprint was a roller coaster ride, full of mission critical Product Backlog…

From Fritzing to Circuit Maker – Changing EDA Software

Development News

Holoseat continues to march forward, but we have started having issues with our electronic design (EDA) software, Fritzing.  Fritzing is a great product, however as we increase complexity and add new components sourcing accurate libraries is becoming a…

2017 Sprint 2 Kick Off – Implementing HID on v0.4

Development News

This post is part of a series covering Holoseat’s development. Look for one at the start of each sprint covering where we have been and where we are going. The Big Picture We just wrapped up Sprint 1…